Daktronics All Sport 5000 Manual de usuario descargar pdf (Pagina 4)

All Sport 5000 Series Console Quick Start Guide 4 of 4

201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128

Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4700

Web: www.daktronics.com/allsportsupport

DD2077845 Rev 1

26 July 2012

Jacks & Switches

 J1-J3 (SCOREBOARD OUTPUTS) – These are ¼" stereo

jacks used to connect directly to fixed-digit scoreboards,

clocks, and stat displays. J1, J2, and J3 all send out the

same scoreboard control signal.

For wireless systems, these jacks may not be needed. If the

console is equipped with a radio antenna, ensure that it

is pointed straight up during operation for best results.

 J4 (MAIN CLOCK START/STOP/HORN SWITCH) – This jack is

used for a main clock handheld start/stop switch. J4 may also be used

for external Precision Time console (for basketball).

 J5 (COMPUTER PORT) – Not used on this model

 J6 (I/O PORT) – This jack is the main input and output port. J6 is used

to send data to multiple displays (Scoreboard, Play Clock, and Locker

Room Clocks), communicate with other All Sport consoles, and send

Real-Time Data (RTD) to Daktronics display controllers.

 J7 (PLAY CLOCK START/STOP/RESET SWITCH) – This jack is

used for a play clock handheld start/stop/reset switch.

 J8 (SWITCH INPUTS) – Not used on this model

 S1 (POWER) – This switch is used to power the console ON and OFF.

Important Safeguards

1. Do not drop the control console or allow it to get wet.

2. To avoid electrical shock, do not disassemble the control

equipment or electronic controls of the display; failure to follow

this safeguard will also make the warranty null and void.

3. Always turn off and/or unplug the control equipment when it is

not in use. Never yank the power cord to pull the plug from the

outlet. Grasp the plug and pull to disconnect.

4. Do not let any power cord touch hot surfaces or hang over the

edge of a table that would damage or cut the cord.

5. If an extension cord is necessary, a three-pronged, polarized cord

should be used. Arrange the cord with care so that it will not be

tripped over or pulled out.

6. After receiving a new or replacement console, inspect for

shipping damage such as rattles and dents, and verify that

all equipment is included as itemized on the packing slip.

Immediately report any problems to Daktronics; save all

packing materials if exchange is necessary.

1 2 3 4

Comentarios a estos manuales

Sin comentarios

Daktronics All Sport 5000 Manual de usuario Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Relojes deportivos Daktronics All Sport 5000