All Sport 5000 Series Console Quick Start Guide 2 of 4
201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4700
Web: www.daktronics.com/allsportsupport
DD2077845 Rev 1
26 July 2012
NNNN = last code selected
NNNN = current code entered
X = current broadcast group
YY = current radio channel
Start Up
1. Plug power cord into a 120 (or 230) VAC outlet.
2. Connect all signal cables to their appropriate jacks, if they are not
already connected. Wireless radio systems may not require these
signal connections. Refer to scoreboard installation manuals
and/or site-specific System Riser Diagrams for more information.
3. Slide a sport insert into the sleeve over the keypad (see Page 3).
4. Turn power switch S1 on rear of console to the ON position.
5. The console will perform a self-test when it is powered on.
During the self-test, a message will display the version of the
standard software loaded in the console:
6. When the self-test completes, a prompt displays the code number
for the last game played. This is useful when power to the console
is lost during a game.
Press <YES> to resume the last game stored in memory.
The console is now ready for game operation.
Press <NO> to start a new game or change sports. The console
will prompt for a new code number as shown below.
Use the number keypad to enter the new sport code, and then
press <ENTER>. Sport codes can be found on the sport-specific
insert and in the Operations Manual. Refer also to Page 3.
Radio Settings
If the radio option is installed, the console will also prompt for
the radio settings after changing the sport code. Press <ENTER>
to accept the current settings or press <CLEAR> to modify them.
The radio settings in the console (transmitter) must match
the settings in the scoreboard (receiver). By default, both are
set to Broadcast Group 1, Channel 01.
To determine the settings of a scoreboard, first power it
down and shut off any radio-equipped consoles in the area.
Next, power the scoreboard back up and watch for the radio
settings. The settings will appear as “bX CY” where X is the
current broadcast group and Y is the current channel:
The settings are typically displayed in the clock digits or Home
and Guest score digits, depending on the scoreboard model.
Refer to Section 2.4 of the Operations Manual for more
information on radio settings.
V = version and revision number
ED = standard software number
Radio Settings in Clock Digits
PREV CODE NNNN
RESUME GAME?
RADI O SETTI NGS
BCAST X CHAN YY
(25 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales