Daktronics Show Control System Manual de usuario descargar pdf (Pagina 93)

86 Daktronics Show Control System Scripting

4. Select Custom ERTD Script. Click the radio button next to the custom script you wish to create. Use

the scroll bar on the right to view all available choices. Proceed to the next step.

5. Set Custom ERTD. Enter the applicable information for the custom ERTD script.

6. The following are common steps which are required to create a custom script:

a. Protocol: In most cases, UDP/IP should be selected. In instances where it is necessary to transmit

a script to a different subnet, however, TCP/IP and IP Multicast are available options.

b. Address: In most cases, the default value of 255.255.255.255 should be used. When sending a

script to a different subnet, however, a different IP address may be entered.

c. Port: Changes to this number are usually not necessary. By default, the Port number for scripting

is set to 27000. Follow the below steps if you wish to confirm the correct port number for your

sign(s).

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 145 146

Sin comentarios

Daktronics Show Control System Manual de usuario Pagina 93