Daktronics Rodeo Interface with Daktronics Matrix Displays Manual de usuario descargar pdf (Pagina 19)

Venus 7000 Connection Methods 13

This section explains the setup of the OmniSport

2000 timing console and DakStats

3000 Rodeo

software to a Venus

7000 controlled display.

The components needed are a Venus 7000 controller, DakStats 3000 Rodeo software, an OmniSport

2000 console, and a Daktronics video display.

Optional components include a Push Button Interface, Judges Consoles, Photocells, Daktronics

Communications Server (DCS) software, a Microsoft Loopback Adapter, and a network hub (for

network communication method).

System Riser, Rodeo, Pro Star .............................................................. Drawing B-320179

The OmniSport 2000 uses photocells, pushbuttons, judges consoles and the rodeo interface, to

time and score rodeo events for display on numeric scoreboards and matrix displays, and can

also send that data to DakStats 3000 Rodeo software. This section focuses on connecting the

OmniSport to the video display and to DakStats 3000 Rodeo software.

1. Connect a straight through 9-pin male to 9-pin female serial cable (W-1267) from the

Results Port (J6) on the OmniSport 2000 console to an available COM port on the

computer with the DakStats 3000 Rodeo software.

2. Connect a straight through 9-pin male to 9-pin female serial cable (Daktronics part

number W-1267) from the RTD Port (J5) on the OmniSport 2000 console to an

available COM port on the Venus 7000 computer.

Note: Typically the connection from the OmniSport 2000 to the RTD input in the

Venus 7000 computer is serial. In special cases, the signal may be routed through

Daktronics Communication Server (DCS) and sent over a UDP/IP socket instead.

Refer to Section 2.5 for more information about configuring DCS.

The DakStats 3000 Rodeo software needs an input configured to receive times and scores

from the OmniSport 2000 console and a separate output to send RTD to the Venus 7000. Refer

to the DakStats 3000 Rodeo Software Installation & Operation Manual (ED-14946) for more

information on setting up this program.

The DakStats 3000 Rodeo software and the Venus 7000 software typically communicate via a

network connection. In rare cases, a serial connection may be used. When using network

communications, the Venus 7000 computer and the DakStats 3000 Rodeo computer must be

networked together on the same Subnet/IP range. If the DakStats 3000 Rodeo software is

installed on the Venus 7000 computer and it is not plugged into a router, a Microsoft

Loopback Adapter must be installed to allow network communication between the two

programs. Visit http://support.microsoft.com/kb/839013 for more information about

installing the loopback adapter.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 44 45

Sin comentarios

Daktronics Rodeo Interface with Daktronics Matrix Displays Manual de usuario Pagina 19