Daktronics PC-2001 Manual del operador Pagina 73

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 300
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 72
Scoreboard Outputs
Select Scoreboard Outputs to assign a protocol
used to transmit data in outputs (J2 and J3).
Press [] or [] to select Multicast, Multidrop, Multiline or Omega protocol, depending on
the type of display used and then press [Enter] to save.
When to use this:
The OmniSport 2000 supports several generations of displays. Currently there are
three different types of Daktronics protocols. Multicast, Multidrop, and Multi-line.
The newest generation of display for aquatics is the SW-5000 series. This series of
display will auto-detect the protocol being sent by the OmniSport 2000 console. In
most cases the console should be set to Multicast.
The previous generation of displays for aquatics was the SW-2000 series. This
generation required a protocol plug to determine which protocol it was receiving. To
test which protocol is configured, unplug the signal to the display from the back of
the console. Cycle power to the display. When it powers up, the display will show
either P0 or P1 on the left two digits.
P0 console to Multidrop
P1 console to Multi-line.
An OmniSport 2000 cannot run a Daktronics glow cube display directly. A glow cube
display will require an interface in order to be controlled by an OmniSport 2000
console. When using a glow cube interface, set the OmniSport 2000 console
to Multidrop.
If the display is one manufactured by Omega, set the console to Omega.
RTD Configurations
The RTD Port is used to select the protocol (RTD or CTS)
to transmit out of the J5 RTD port on the OmniSport 2000
console. RTD means Real Time Data. CTS means Colorado
Timing System. The default is RTD.
Press [] or [] to select RTD to send information to a Venus
®
controller or CTS to send to a
numeric CTS scoreboard. Press [Enter] to accept the setting.
Results Port
The Results Port configures which protocol
(OmniSport 2000 or 6000 console, or a CTS console) will be
used to communicate with the meet management software.
MENU-COMM PORTS
1-SCBD OUTPUTS
MENU-COMM PORTS
SCBD MULTIDROP*
MENU-COMM PORTS
2-RTD PORT
MENU-COMM PORTS
RTD PORT: RTD*
MENU-COMM PORTS
3-RESULTS PORT
COMM PORTS
RSLT: OMNI 2000*
MENU-COMM PORTS
CTS PORT: CTS
From Main Menu [4]>[4]>[3]
From Main Menu [4]>[4]
From Main Menu [4]>[4]>[1]
From Main Menu [4]>[4]>[2]
Vista de pagina 72
1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 299 300

Comentarios a estos manuales

Sin comentarios