Daktronics KE-1010-7.6-RG Manual de usuario descargar pdf (Pagina 15)

Mechanical Installation

2-3

1. Before attempting to connect the sections, check their alignment in relation

to each other. If the alignm

ent is off, then you may need to adjust the

mounting clips on the back of the tickers.

2. Hang each section (refer to the appropriate following subsection).

3. Refer to Section 3 for routing power and signal to each section.

4. Slid

e the sections together.

5. Slide the splice bar over the joint(s) between the displays.

6. Tighten the screws (provided in the splices) using a

″ hex wrench.

Hanging Mount

Reference Drawings:

Mounting Drawing, Ceiling, KE-1010

............................Drawing A-118572

Splice bars, provided by Daktronics, have 3/8″-16 UNC

hol

es that can be used to

secure the ticker displays from a ceiling or other overhead structure. Use the middle

hole only when using the splice bars for mounting. To hang a ticker, refer to

Drawing A-118572 and the following instructions:

1. If i

t has not already been done, unpack the display and check for any

dam

age that may have occurred during shipping.

2. Determ

ine and mark the locations where the ceiling m

ounting supports will

attach to the overhead structure. The supports, when installed, should form

a 90-degree angle with the top of the display (refer to Drawing A-118572).

Daktronics does not provide the ceiling mounting supports.

3. Install the supports. Qualified personnel m

st approve the ceiling mounting

supports. Daktronics is not responsible for ceiling mounting.

4. Secure t

e splice bars to the supports.

5. Carefully hang each display by fitting the channel on the top of the display

over the spice plates and slid it into place (refer to Drawi

ng A-118572).

When multiple section displays are used, each joint between displays

must have hanging support.

Wall Mount

Reference Drawings:

Mounting Drawing, Wall, KE-1010-16 ...........................Draw

ing A-118222

Mounting Drawing, Wall, 15 Deg...................................Draw

ing A-119539

Mounting Drawing, Wall, 30 Deg. .................................Drawing A-119553

Wall Mounting, KE-1010-2-16x***-7.62.........................Draw

ing A-210488

Detail, Horiz. Wall Mounting, KE-1010-24x***-7.62 ......Drawing A-214525

Shop Drawings .......................................................... Refer to Appendix A

Hang t

he master ticker using the mounting clips on the back of the display (refer to

Draw

ngs A-118222, A-119539, A-119553, A-210488, and A-214525 for the type

of wall mounting used and the Shop Drawings for the location of the display’s

mounting clips). The clips fit into the slots in the mounting bracket.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 63 64

Comentarios a estos manuales

Sin comentarios

Daktronics KE-1010-7.6-RG Manual de usuario Pagina 15

Comentarios a estos manuales

Relacionado con productos y manuales para Monitores Daktronics KE-1010-7.6-RG