Daktronics CH-1036V Manual de usuario Pagina 18

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 24
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 17
Maintenance &
Troubleshooting
3-2
3.3 Digit Segmentation
Reference Drawing: Segments, 4x7 Lamp Matrix Digit.................. Drawing A-37685
Refer to Drawing A-37685. In a digit, certain lamps always go on and off together. These
groupings of lamps are knows as segments. Each digit has eight segments, referred to by
letters A through H.
3.4 Fuses
Reference Drawing: Lamp Driver, 16 Col. w/ Fan.......................... Drawing A-37070
Refer to Drawing A-37070. The lamp driver has 17 fuses. There is one fuse to protect each
digit circuit. F1 through F16 are type AGC-10 and are located near each output connector
under the driver’s metal cover. The other lamp driver fuse, F17, is type AGC-1/2 and it
protects the driver’s logic circuit and fan.
3.5 Schematic
Reference Drawing: Schematic, 1 Driver Display .......................... Drawing A-46754
The schematic diagram in Drawing A-46754 shows the power and signal inputs into the
display and to the lamp driver.
3.6 Troubleshooting
Observed Problem Possible Cause
One lamp won’t light
Burned-out lamp
Broken wire behind digit
Digit segment won’t light
Broken wire
Poor contact at driver connector
Internal driver malfunction
Entire digit won’t light
Broken wire (black)
Poor contact at connector, pin 7
Fuse blown in driver
Half the display won’t light
Service breaker tripped
Main fuse blown
Poor contact at main power connection
P18 disconnected
Entire display won’t light
Power disruptions
Poor signal connection
Driver logic fuse blown
Control not connected to display
P20 disconnected
Segment stays lit
Broken wire behind digit
Internal driver malfunction
Garbled display
Control malfunction
Internal driver malfunction
Vista de pagina 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Comentarios a estos manuales

Sin comentarios