Daktronics Remote Control System RC-100 Manual de usuario descargar pdf (Pagina 25)

RC-100 Handheld Controller 19

Up/Down

Arrows

These keys are used to navigate through menu choices and

make certain selections. Arrows may also be assigned to

application-specific functions.

ON/OFF

CLEAR/NO

ALT

The ON/OFF operation of this key is described in Section 4.1.

The CLEAR operation of this key pertains to editing and data

entry routines. When editing a value, press <CLEAR> to

remove that value. The CLEAR operation may also be used to

escape out of an editing function. If a key was pressed

inadvertently, or if the value being edited should not be

changed, pressing <CLEAR> twice exits the editing routine

without modifying the value.

The NO operation of this key also pertains to editing and data

entry routines. When a question prompt is shown on the LCD,

press this key to answer the question with a “No.”

The ALT operation of this key selects alternate actions for

certain application keys. Press this key before pressing

another key to activate a secondary function. Refer to the

section following this table for more information.

CONFIG

ENTER/YES

EDIT

The CONFIG operation of this key is described in Section 4.4.

The ENTER function of this key pertains to editing and data

entry routines. After editing a value, press <ENTER> to save

the change.

The YES function of this key also pertains to editing and data

entry routines. When a question prompt is shown on the LCD,

press this key toanswerthequestionwitha“Yes.”

The EDIT function of this key is used to edit the data

associated with a particular key. For instance, pressing

<EDIT> followed by a “+1” key will allow the operator to

manually type in a new value using the number keys. Refer to

the application-specific sections for more information about

which keys have EDIT functionality.

Alternate Function Keys

An alternate function of a key, if applicable, will be

shown on the bottom the key below a horizontal line.

Refer to Figure 15 for an example.

 Press the key once to run the primary function.

 Press <ALT> followed by the key to run the alternate function.

Figure 15:

Key with ALT Functionality

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 53 54

Comentarios a estos manuales

Sin comentarios

Daktronics Remote Control System RC-100 Manual de usuario Pagina 25

Comentarios a estos manuales

Relacionado con productos y manuales para Panel De Control Daktronics Remote Control System RC-100